This cabinet has about three times as much storage as a typical medicine cabinet.
It’s also a great project for a woodworking novice, thanks to simple joinery and a readymade door.
Assembling the top and base are the trickiest bits. A single louvre door is cut in half to form two. Recycle a wardrobe door or buy one for about $25.
You may need to adjust the height and width of the cabinet to suit your door (this one measured 1650 x 300 x 19mm). So buy the door first then alter the carcass and shelves as necessary.
Cut all parts to size (refer to Cutting List above). Assemble the carcass with glue, screws and dowels. Drill 3mm pilot and countersink holes for screws (see Diagram above) and use a 10mm brad point bit for the dowels. TIP Ensure the box is square before drilling dowel holes.
Using a scrap of pegboard for positioning, drill shelf support holes. Wrap masking tape around the drill bit to prevent drilling right through. Set the 5mm or 6.5mm holes, depending on the support, 40mm in from the front and back edges of the sides.
Lay the door face down (so any splintering happens on the back) and cut in half using scrap timber as a saw guide. To finish, sand the cut edges with 120-grit abrasive paper.
Position the hinges 75mm from the top and base of the doors. Use a self-centring drill bit to position the screw holes then fasten the hinges.
TIP Use a non-mortice type hinge for easy fitting.
Measure the top of the cabinet (including doors) to cut the top and base frames. Set a mitre saw to 45o and position the moulding upside down, against the fence. Clamp a block to the fence to secure the moulding while cutting.
Pre-drill nail holes to avoid splitting. With the sides in place, add the front top moulding. Cut slightly long and shave one end with a mitre saw for a tight fit. Add the moulding to the base frame the same way.
Fasten top with screws from the inside and attach base the same way. Cover dowels, screws and nail heads with filler then sand. Apply primer and two coats of acrylic enamel. To hang, use 65mm x 10g screws through the top and base cleats into wall studs.